How to Measure Your Cubicle Panels for Extenders
Mitchell KirschAdding extenders to your existing cubicle panels is a cost-effective way to increase privacy, reduce noise, and redefine your office space without the expense of new furniture. However, the success of this upgrade depends entirely on accurate measurements.
This guide, based on the detailed instructions in our infographic, breaks down the two critical steps required to ensure your new cubicle extenders fit perfectly.
Introduction: The Importance of Precise Measurement
Before you shop for panel extenders, you must gather two key pieces of data: the length of your panels and the thickness of your panels.
Incorrect Length: If your measurement is too long, the extender will not fit between posts. If it’s too short, there will be a visible gap.
Incorrect Thickness: The mounting hardware (brackets) is the most common point of failure. If the bracket is too narrow, it won't fit over the panel. If it's too wide, the extender will be loose and unstable.
Follow this step-by-step process to get it right the first time.

Step 1: Measure Panel Length (To Determine Extender Size)
The length of your cubicle panel determines the width of the extender you need to order.
How to Measure:
- Locate the Top Edge: Identify the fabric or solid panel section you intend to extend.
- Measure Horizontally: Using a standard tape measure, start from the far left edge of the panel section.
- Exclude Posts: Crucially, do not measure the metal or plastic vertical end caps/posts. Measure only the fabric-covered (or finished) section. The goal is to find the exact space between the vertical posts.
- Record the Measurement: Measure to the nearest quarter-inch.
See the infographic for a visual guide on where the tape measure should start and stop.
What to Order:
Use your measurement to select an extender that matches your panel’s length. Most extenders come in standard widths. Refer to the "Standard Widths & Heights (Inches)" chart in the infographic for common sizes (e.g., if you measure 47.5”, you will likely need a 48” extender).
Step 2: Measure Panel Thickness (To Determine Bracket Size)
The thickness of your panel determines which mounting brackets are required to secure the extender. This is the most critical step for stability.
How to Measure:
- Focus on the Top Cap: You need to measure the full depth of the panel at its top, including the decorative top cap and the frame structure it sits within.
- Measure Across: For the most accurate reading, use calipers. Place one jaw on the outermost front edge and the other jaw on the outermost back edge of the top cap. This gives you the total, finished thickness.
- Alternatively: If you do not have calipers, use a precise tape measure or ruler. Measure the distance from the outside front edge to the outside back edge at the top of the panel.
The infographic provides a detailed close-up of this measurement process, showing the correct placement of calipers.
What to Order:
Once you have the exact thickness measurement, you must select the bracket size that matches it. There is no "rounding up" here; the bracket must fit snugly. Consult the "Available Cubicle Bracket Sizes" chart in the infographic:
- Small Bracket: Fits 1" to 1.5" thick panels.
- Standard Bracket: Fits 1.5" to 2.5" thick panels.
- Large Bracket: Fits 2.5" to 3.75" thick panels.
Select the size range that your specific measurement falls within.
Conclusion: Ready to Upgrade
By following these two simple steps, you eliminate the guesswork and ensure a secure, professional installation for your new cubicle extenders. Accurate length ensures a seamless look, and accurate thickness ensures a stable, safe addition to your workspace.
Once you have your two measurements, you are ready to confidently order the perfect extenders and brackets for your office.